2842 - Exeron HSC-Line Digma 5-Axis Machining Centre
Engineering
L'enchère s'est terminée le
Temps restant
'Description de l''enchère'
Location: This lot is located in Stirling. Unfortunately, there are no loading facilities on-site, dismantling and loading will be at the cost of the purchaser. All/Any tooling is being offered as specifically described.
Prime d'acheteur
'La prime d''acheteur sera fixée à 18.00%.'
TVA
'La taxe sur la valeur ajoutée s''élèvera à 20.00%.'
Temps de consultation
Viewing will be available by appointment only with the Auctioneer. Please contact our Office on: +44 (0) 121 328 2424 or email us at: info@cottandco.com
* Remarque : Toute traduction effectuée à l'aide de Google Traduction n'est pas garantie en tant que traduction exacte et n'est fournie qu'à titre indicatif. La description du lot en anglais est la description prédominante et bénéficie de la meilleure connaissance du commissaire-priseur. Cependant, l'exactitude n'est pas garantie et doit être vérifiée par l'acheteur avant d'enchérir.
Avis aux acheteurs
Date limite de paiement
'Date limite d''apurement'
'Agents d''expédition'
Sous-traitants pour le stockage
Exporter/Importer des détails du Royaume-Uni
Lots 1-1 de 1
Lot 100: Exeron HSC-Line Digma 5-Axis Machining Centre
Exeron HSC-Line Digma 5-Axis Machining Centre, Rotary Table
Surface 460mm Diameter, Traverses: X = 800mm. Y = 800mm. Z = 500mm,
C (Table Rotation) = 360 deg, B (Table Tilt) 105 deg, Milling
Spindle Nose HSK 50, Max Spindle Speed 42,000RPM, Spindle HVC 150,
27-Position Tool-Changer, Infrared caliper Renishaw (Laser Tool
Setter), Tool Length Measuring, Tool Diameter Measuring
Electronic Hand-Wheel, Cooling Aggregate, Graphite
Preparation (2006)
The machine was fully serviced/overhauled in 2015 by Exeron with new ball screws being fitted, the machine realigned with a ball bar and the 5 axis unit fully checked and realigned plus a standard PM service and grease etc.
Please Note: This lot is located in Stirling. Unfortunately, ...