2823 - Hurco Vertical Machining Centres, Sodick & Agie EDM'S, Toolroom Equipment and Ancillaries no longer required due to Investment in New Equipment by The Goodfish Group, Cannock
Engineering
L'enchère s'est terminée le
Temps restant
'Description de l''enchère'
Location: These lots are located in Cannock. Unfortunately, there are no loading facilities on-site, dismantling and loading will be at the cost of the purchaser. All/Any tooling is being offered as specifically described.
Lot 107A however is located in Birmingham.
Prime d'acheteur
'La prime d''acheteur sera fixée à 16.00%.'
TVA
'La taxe sur la valeur ajoutée s''élèvera à 20.00%.'
Temps de consultation
Viewing will be available by appointment only with the Auctioneer. Please contact our Office on: +44 (0) 121 328 2424 or email us at: info@cottandco.com
* Remarque : Toute traduction effectuée à l'aide de Google Traduction n'est pas garantie en tant que traduction exacte et n'est fournie qu'à titre indicatif. La description du lot en anglais est la description prédominante et bénéficie de la meilleure connaissance du commissaire-priseur. Cependant, l'exactitude n'est pas garantie et doit être vérifiée par l'acheteur avant d'enchérir.
Avis aux acheteurs
Date limite de paiement
'Date limite d''apurement'
'Agents d''expédition'
Sous-traitants pour le stockage
Exporter/Importer des détails du Royaume-Uni
Lots 1-1 de 1
Lot 100: Hurco VMX 30 Vertical Machining Centre
Hurco VMX 30 Vertical Machining Centre with Ultimax Control, 24 ATC, Table Size 1000mm x 500mm, CAT40 Tooling with 10-Tool Holders. S/No. H-30353 (2003)
Please Note: This lot is located in Cannock. Unfortunately, there are no loading facilities on-site, dismantling and loading will be at the cost of the purchaser. All/Any tooling is being offered as specifically described.